© Copyright
Mervyn Passmore 2008
Marblack Slate Blacking Home

Reassemble the clock by fitting the movement back into the bezel and replacing the edge screws. Some clocks have a timekeeping adjuster protruding through the dial. Don't push hard, as the dial is probably enamel can easily chip or crack.

Carefullly fir the movement bac in the case and secure it to its backplate. Make sure the figure 12 is at the top, but do not fully tigthen the screws in the back.Don't refit the pendulum until the clock is in its final position.



Refit the back screws